Also, if the intake air temp is cooler, you will also make more power. The simple facts are that if you keep the coolant temps below 190 degrees, you are going to make more power. Compared to the Koyo, this new radiator weighs approx. During controlled dyno tests, we have seen 15-20 degree drops on intake air temps.Reduced intake system air temperatures.We have consistently seen 20-30 degrees cooler temperatures running this new radiator vs a 54mm Koyo radiator or a few of the other copies of our radiator.Reduced cooling system operating temperature.Three main attributes for this radiator are: Many try to copy, but none have been nearly as effective. This is a true triple pass radiator which channels the water from side to side multiple times ensuring a substantially longer cooling time in the radiator and pulling even more heat out of the cooling system. They have been used on 6 of the last 7 national Championship winning cars. There's a reason that so many winners and champions use these radiators, they work better than anything else out there. This is the latest revision to the most effective radiator in the Spec Miata marketplace. Now we needed to race it.Originally built and designed by Sam Henry of Springfield Dyno. After a few hours in the shop, we’d transformed our Miata into a downforce monster. These are easy to put together with cable and eye bolts from the local home improvement store.Īll that was left was the air dam, which installed in a few minutes with the included rivets. Next, we made a pair of support cables to strengthen the outside edges of the splitter. And, spoiler alert, our own testing would later show that this kit made downforce AND improved radiator cooling. We weren’t able to use Nine Lives Racing’s radiator duct, and instead bent up a piece of aluminum to create a clear path for air to flow through the radiator. We then moved to the front of the car, where we had much more work to do: We needed to install the splitter, air dam and radiator ducting, but each part is designed for a stock Miata.Īll this meant the Nine Lives Racing kit didn’t quite bolt on, but fixing it wasn’t too hard: We simply removed the clever quick-release system that anchors the rear of the splitter and replaced it with two bolts that thread into tabs we welded to our V8 Roadsters subframe.Ī little cutting and grinding let the quick-release front splitter mounts, dubbed “Sturdy Bois,” attach around our oversized radiator, which left radiator ducting: We had cooling issues with the factory front bumper, so knew we couldn’t afford to leave anything on the table in this department. We’ll start at zero degrees, then fine tune at the track. Then, we set the wing’s angle of attack using a straight edge and a digital level. Installation involves drilling four holes and shaving down the edges of our trunk lid with an angle grinder. carbon-fiber, it’s actually lighter than most of the other kits on the market: Nine Lives Racing uses a more durable aluminum for the wing uprights, which allows them to be thinner and lighter than some other options. It’s worth mentioning that even though this wing is aluminum vs. Nine Lives Racing supplies a 64-inch-wide aluminum wing in its Medium Downforce Kits, which bolts to the trunk rain gutters via custom-made aluminum uprights. (The Nine Lives Racing site contains a price calculator, with this kit starting around $860–but figure closer to $1500 for something like our setup.)įirst up, the wing. So it only made sense to give our LFX Miata the same treatment. We tested one on a past Lemons build and came away impressed as the kit includes a wing, air dam, splitter, and the proper mounts and hardware to bolt it on the car. Simple: A Medium Downforce Kit from Nine Lives Racing. That led to the question: “What should we add?” We’d tripled our Miata’s OEM horsepower via an LFX swap, and this fact sent chills down our spine: We’ve raced this car at Daytona, and even with only 200 horsepower, it was no fun at higher speeds.Įarly Miatas like ours make boatloads of aerodynamic lift in stock form, and that makes them both harder to drive and slower around a track–not exactly great attributes for a race car.įortunately, we can fix it: Since we’ll be running this car in series like Lucky Dog, AER and WRL, we’re allowed to add aerodynamic elements to the car.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |